Gumpaste Daffodil Tutorial

Gumpaste Daffodil Tutorial

Sometimes I want to make a flower and I don't always have the exact cutters and/or veiners necessary. If am lucky I have something close enough to use. This I found what I used to make the daffodil...

Supplies I used
Round cutter
small leaf cutter
Rolling pins both to roll and hallow out
desden tool
Silk veining tool
28g wire
celboard
Celpad with 3 holes (if you don't have this roll a ball of paste into a cone and hallow out)

• Roll paste over the largest hole and cut shape with a small round cutter (size of the cutter depends on the size of the flower you want) 

Roll gumpaste in large hole

Cut out using small round cutter

• Now you will frill the edges and hallow out the center using the dresden took, silk veining tool and rolling pin. I first hallow it out a bit the celpin. Next I frill the edge with the dresden tool to pull out the tips some, then I use the silk veining tool to smooth. (Try different methods to achieve the look you like)

Hallow out center with celpin

 

Soften with silk veining tool

Frill with dresden tool

• Now you will attach it to center stamens. Add a bit of egg white inside at the base sliding in the stamens. Pinch gently around the base to attach and stand in styrofoam to dry. 

Stamens and bell shape

Center complete

Making the stamens isn't shown

The stamens are made using 30g or 33g wire and rolling a very tiny ball of paste on it. Make 6 of these. The center stamen is made with the same idea except use a heavier wire and leave a tiny ball at the top. Flatten it standing it on the top take a dresden tool or pointed end of smallest celstick and pull out the edges.

• Using a small basic leaf cutter cut out 6 petals and wire with 28g wire. I veined them using the Stargazer lily veiner which looks very similar. Soften the edges and let dry in cupped shape.

Veining petal

Soften petal after veining

Drying the petals

• After it is all dry add the color. I added touches of orange around the tips then blended it in with the yellow. Just to highlight. Add yellow over the whole petal if you want a brighter look or you can just leave it. 

Adding Orange Petal dust on edges

Adding Yellow over the Orange

• You can now wire the entire piece. Tape 3 petals around the base in a triangle arrangement and 3 more below those again in a triangle shape to fill in the gaps.

Gumpaste Daffodil

Creating Gumpaste Leaves Quick and Easy

Just a few supplies needed and you are ready to begin... 

Board to work on

Softening pad

Cornstarch, wires, egg white or gum glue

Spatula and/or Veiner

Drying container

1. Roll a ball of gumpaste
Note- Depending on how large a leaf you want depends how big a ball of gumpaste is needed. 
2. Shape it into a cone shape, insert a wire and taper the bottom to a point too.

3. Using either a spatula or veiner flatten the ball of paste. If you are veining the leaf you can use the veiner
Note- use cornstarch to prevent sticking to the board and veiner when flattening

 3 After it is flattened roll it upwards to elongate and thin out further.

 4. Place on veiner and gently vein, soften the edges then pinch the central vein.

5. Shape leaf and place on tray to dry. Since these are so small they dry quickly and don't loose shape laying in a tray. If you make larger leaves you can lay on foam or put fewer in container.

 You are ready to add the petal dust and assemble...